Elastocaloric effect on natural rubber and terpolymer : Temperature variation mechanism, morphology and energy balance during deformation - TEL - Thèses en ligne Accéder directement au contenu
Thèse Année : 2016

Elastocaloric effect on natural rubber and terpolymer : Temperature variation mechanism, morphology and energy balance during deformation

Effet élastocalorique dans le caoutchouc naturel et le terpolymère : Mécanismes responsables de la variation de température et bilan énergétique sous déformation

Résumé

Caloric effects (CEs), which are the phenomena that temperature variation is caused by entropy change, have been investigated for the novel system which might be able to replace conventional vapor compression refrigeration system. In the present thesis, the elastocaloric effect (ElCE) of natural rubber (NR) and terpolymer, poly(vinylidene fluoride-trifluoroethylene-chlorotrifluoroethylene) (P(VDF-TrFE-CTFE)), was focused. First of all, NR, which is an excellent candidate material for ElCE, was evaluated in cyclic deformation with different strain levels. It was found that NR exhibits temperature variation of around 4.0 °C. In general, the relation between stress/strain versus temperature variation is used to evaluate ElCE. The unsuitability of such evaluation method for NR was demonstrated. The evaluation method for ElCE which uses energy balance was then proposed. A linear relation between the temperature variation caused by ElCE and the applied mechanical energy by deformation was experimentally found. This fact verifies the suitability of the proposed method. Using the energy balance, besides, not only the conversion efficiency but also the influences of the Mullins effect and the strain-induced crystallization on the ElCE of NR were discussed. ElCE of P(VDF-TrFE-CTFE) was also evaluated in order to find out the potential of polymer. It was found that present terpolymer which is not one of the elastomers can also exhibit a large temperature variation, 2.1 °C, caused by ElCE if a large pre-stretch such as more than 1050 % is applied in advance. By comparison with other materials for ElCE, it was demonstrated that P(VDF-TrFE-CTFE) can be a high potential material for ElCE. It was also shown that P(VDF-TrFE-CTFE) converts most of the applied mechanical energy into the heat energy.
Les effets électrocaloriques, qui se traduisent par une variation de température induite par une variation d’entropie ont été étudiés comme alternative aux systèmes de réfrigération utilisant un cycle de compression/détente. Le travail de thèse se focalise sur l’étude de l’effet élastocalorique dans le caoutchouc naturel et le terpolymère (P(VDF-TrFE-CTFE). En premier lieu, l’effet élastocalorique dans le caoutchouc naturel qui compte parmi les meilleurs candidats, a été évalué pour des cycles de déformation réalisés avec différentes valeurs d’allongement. Une variation de température de 4 °C a pu être observée. Il est usuel d’utiliser la relation déformation/contrainte en fonction de la variation de température pour évaluer l’effet élastocalorique. Il a été démontré que cette méthode ne peut pas être utilisée dans le cas du caoutchouc naturel et qu’elle doit être remplacée par la mesure de la variation de l’énergie mécanique en fonction de la température. Et dans ce cas, une variation linéaire entre ces deux dernières grandeurs a été observée. En réalisant un bilan d’énergie pendant l’essai, non seulement, le rendement énergétique a pu être évalué mais il a été aussi possible de prendre en compte l’effet Mullins et la cristallisation induite par la déformation pour le caoutchouc naturel. Dans un second temps, l’effet élastocalorique a été étudié sur le terpolymère (P(VDF-TrFE-CTFE), ce qui a permis de montrer qu’il était possible d’obtenir une variation de température de 2.1 °C sous réserver de pré-déformer le terpolymère à plus de 1050 % avant. Par comparaison avec d’autres matériaux présentant une bonne conversion élastocalorique, le fort potentiel de ce matériau a pu être mis en évidence. Enfin, il a été mis en évidence que la plus grande partie de l’énergie mécanique était bien convertie en énergie thermique.
Fichier principal
Vignette du fichier
these.pdf (5.1 Mo) Télécharger le fichier
Origine : Version validée par le jury (STAR)

Dates et versions

tel-01695532 , version 1 (29-01-2018)

Identifiants

  • HAL Id : tel-01695532 , version 1

Citer

Yukihiro Yoshida. Elastocaloric effect on natural rubber and terpolymer : Temperature variation mechanism, morphology and energy balance during deformation. Materials. Université de Lyon, 2016. English. ⟨NNT : 2016LYSEI070⟩. ⟨tel-01695532⟩
201 Consultations
556 Téléchargements

Partager

Gmail Facebook X LinkedIn More